포세이돈 바지선으로 사용
임시 BRIDGE

FAQs on Portable Sectional Poseidon® Barge

Draft is the amount of barge which is below the water surface. Free board draft is the amount of barge that is above the water line. For example, a P1 40′ x 10′ x 5′ barge will draft empty at 1′ and have a free board draft of 4′.

The Poseidon 1, 포세이돈 2 & 포세이돈 3 – 5′ barges draft about 1’ or 12 inches empty. P2-7′ barges draft 1’4″ empty

The spud is an over sized “Nail” which anchors the barge in place by free falling the spud into the river or lake bottom. The spud is fabricated from 18” x 1/2” wall pipe, has a 20”sheave (a round thimble) at the bottom for P1 & P2 5′
제이에프. The spud is for P2 – 7′ barges is fabricated from 24″ x 1/2″ round pipe. The spud pocket mounts on the side of the barge at any two connection points.

The spud pockets are external mount and are attached at any two connection points. This gives you the flexibility to position the spuds on your barge so that they are not in your way while completing your work.

The Poseidon 1 Barge has a Rendrag® compatible connection system. The majority of our rental fleet is the Poseidon I style barge. It is the easiest of the three connection systems to assemble and knock down. The Poseidon 2 Barge has a Flexifloat® compatible connection system. If you already own Flexifloat barges and wish to rent or purchase additional units, this would be an option for you. The Poseidon 3 Barges has a Shugart® compatible connection system. If you already own Shugart® Barges, our units will pin up to theres, are less expensive to transport by truck and are easier to rig with the single pick lifting clevis in the top center of the barge.

Our corporate office and main inventory location is in Berne, 에서. 우리는 또한 Plain에 위치한 위성 분배 야드를 가지고 있습니다., WI; 코코아, FL; 윌턴 양탄자, NY; 성. 루이, MO; 뉴 올리언스, 그만큼; 그리고 리랜드, NC.

계약자는 프로젝트에서 돌아온 바지선의 모든 수리에 대한 책임이 있습니다.. 장비를 바지선 위로 걸을 때 바지선 표면을 보호하기 위해 크레인 매트를 사용하시기 바랍니다.. 이렇게 하면 상판이 굴러가지 않습니다.. 이것은 또한 바지선 구성의 더 큰 부분에 부하를 분산시키는 데 도움이 됩니다.. 바지선에 용접된 모든 브래킷을 제거하고 바지선을 반환하기 전에 나머지 용접부를 연마해야 합니다.. 수리를 위한 사진과 견적은 가능한 한 빨리 귀하에게 전달됩니다.. 수리 비용은 다시 청구됩니다..

익스테리어 보텀스, sides and ends are fabricated with grade A36 – 1/4″ steel. The tops are fabricated with Patented Heavy Duty Roll Form, HSLA Steel Deck Construction with 20,000 psf concentrated load capacity.

We currently offer a ramp for the P2 – 5′ barges and are designing a similar ramp section for P1 – 5′ barges as well as P2 – 7′ barges. Another cost effective way to load your equipment on the barges is to use your 12″ wood crane mats. The barges should remain free floating while the equipment weight transitions from the land to the barge.

The Poseidon Barges are designed to be used only when floating in the water. “Beaching” the barges will create pivot points between the barge that is beached and the barge that is floating. Depending on the weight of the equipment, the connections will either crush in at the top or be pulled out at the bottom.

포세이돈 1, 포세이돈 2 & 포세이돈 3 barges which were built beginning in 2010 are built with a 18″ standard hatches in the tops of the barges. Older units are accessible using the 4 ballast tubes in the top corners of the barges.

There may be some options for Lease to Own or Financing, but they must be discussed prior to entering an agreement. There could be special terms or fees involved. Or, you may finance through an outside banking institution. Leasecorp, Inc in Noblesville, IN has handled financing for some of our customers in the past.

Our sales representatives will assist you in setting up the barges. Typical setup depending on the size of the platform, can be completed in less then a day. This can be scheduled while arranging for delivery of the barges.

Each Poseidon 1, 포세이돈 2 or Poseidon 3 – 40’ x 10’ x 5’ barges will float 35,000 lbs dead weight at 2’6” draft. A 20’ x 10’ x 5’ barge will float 17,500 lbs dead weight at 2’6” draft. (For example, 6 – 40’ x 10’ x 5’ barges will float 210,000 lbs or 105 tons at 2’6” draft.) P2 – 7 바지선: 40′ = 27.1 tons at 3.5′ draft.

Poseidon I Barges
P1 – 40’ x 10’ x 5’ sections 23,500 lbs each
P1 – 20’ x 10’ x 5’ sections 12,600 lbs each
P1 – 10’ x 10’ x 5’ rake sections 6,500 lbs each
P1 – 5′ Spud Pocket 1,250 lbs each
40’ x 18″ Round Spuds 4,400 lbs each
30’ x 18″ Round Spuds 3,300 lbs each
20’ x 18″ Round Spuds 2,200 lbs each
P1 – 5′ Hairpin Connector Pins 55 lbs each

Poseidon II Barges
P2 – 40’ x 10’ x 5’ sections 23,500 lbs each
P2 – 40′ x 10′ x 7′ sections 33,000 lbs each
P2 – 20′ x 10′ x 5′ sections 12,500 lbs each
P2 – 20′ x 10′ x 7′ sections 17,070 lbs each
P2 – 5′ Spud Pockets 2,550 lbs each
P2 – 7′ Spud Pockets 4,350 lbse each
P2 – 7′ 24″ x 1/2″ x 40′ Round Spuds, 12,300 파운드

Poseidon III Barges
P3 40’4″ x 10’4″ x 5′ Sections weight 23,700 lbs ea

한 감자가 제자리에 바지선 앵커 수면 아래 바닥으로 하강. 땅의 표면과 물 전류에 따라, 당신은 사용해야 할 수도 있습니다 4 욕구가 마구 후 오히려 2 장소에 바지선을 고정하기. 한 감자는 윈치 시스템이나 크레인 선을 이용하여 상승 될 수 저하. 또한, we offer deck cleats which are attached to the top of the barge and can be used to tie off the barge to a close tree or bridge peer.언제든지 케이블은 바지선과 고정 점 사이에 오픈 물에 노출 된 경우, it is critical to mark the cable with bright Orange Vinyl ties so as to warn anyone approaching the job site with a boat or jet ski that the cable is in place and could be a hazard.

The spuds can be raised and lowered with the crane or excavator on the barge. There is a lifting eye at the top of the spud. Make sure you have a choker that is 15′ – 20′ long so that when the spud is lowered into position on the river bottom, you do not need a ladder to climb up to release the crane line. 또한, we lease and sell winches systems to raise and lower the spuds. Steel cable is not provided. Either 5/8″ or 3/4″ cable may be used depending on the type of winch leased or purchased.

Poseidon Sectional Barges are transported via tractor trailer trucks. We have local trucking companies who can haul two-Poseidon 1 포세이돈 2 or Poseidon 3 – 40’ x 10’ x 5’ trucks on a step deck trailer. There is a limited number of light weight trailer available so the more notice you give us the more likely we will be able to accommodate your needs. You may arrange for your own freight as well.

We will assist you in arranging freight. It is the contractor’s responsibility to pay for both incoming and outgoing freight.

The contractor is responsible for insuring the barges while they are in your possession. We will need a Certificate of Insurance naming Poseidon Barge, LTD as an “Additional Insured” under your general liability policy, plus listing us as a “Loss Payee” under your equipment floater policy for dual protection against physical damage. The insurance value would be the original purchase price.

우리는 110 바지선 섹션 뒤쪽에 부착된 HP 유압 바지선 푸셔 장치. 이 장치에는 다음을 제공하는 조정 가능한 프로펠러 시스템이 있습니다. 180 정방향 및 역방향으로 회전하는 정도. 우리 장치를 사용하면 예인선에 앉아 있는 풀타임 선장이 필요하지 않습니다.. 낚싯배를 사용하여 바지선을 이동할 수도 있습니다. 75 에 100 HP 아웃보드 엔진. 케어는 보트 또는 푸시 무릎 예인선을 사용하는 경우 손상으로부터 바지선의 측면을 보호하는 범퍼 시스템을 사용하도록주의해야.

아니! 이는 바지선에 손상을 줄 것이다! 장비가 바지선에있는 동안 바지선은 무료 부동 유지해야.

물에 떠있는 경우에만 무료로 우리의 바지선은 체중을 수행하도록 설계.

우리의 바지선은 바지선의 네 모서리에 밸러스트 튜브가 장착되어. 내부에 배플 벽이 밀봉되지 않습니다. 밸러스트 수를 추가 할 수 있지만 다시 바지선을 출하하기 전에 제거해야합니다. 이 안정기 튜브를 통해 아래로 작은 휴대용 펌프 라인을 사용하여 수행 할 수 있습니다 또는 당신은 양단에 밸러스트 관을 열 수 있습니다, 공기 압축기 라인을 연결하고 다른 쪽 끝에서 물을 날려.

당신은 그러나 우리는 바지선의 구입 가격으로 유료 리스료를 적용 할 수 없습니다 임대의 끝에서 바지선을 구입할 수 있습니다. 당신은 바지선을 구입하고자하는 경우, 구매 조건은 협상 앞까지에 동의.