波塞冬駁船USED AS
臨時橋

FAQs on Portable Sectional Poseidon® Barge

Draft is the amount of barge which is below the water surface. Free board draft is the amount of barge that is above the water line. For example, a P1 40′ x 10′ x 5′ barge will draft empty at 1′ and have a free board draft of 4′.

The Poseidon 1, 波塞冬 2 & 波塞冬 3 – 5′ barges draft about 1’ or 12 inches empty. P2-7′ barges draft 1’4″ empty

The spud is an over sized “Nail” which anchors the barge in place by free falling the spud into the river or lake bottom. The spud is fabricated from 18” x 1/2” wall pipe, has a 20”sheave (a round thimble) at the bottom for P1 & P2 5′
J.F. The spud is for P2 – 7′ barges is fabricated from 24″ x 1/2″ round pipe. The spud pocket mounts on the side of the barge at any two connection points.

The spud pockets are external mount and are attached at any two connection points. This gives you the flexibility to position the spuds on your barge so that they are not in your way while completing your work.

The Poseidon 1 Barge has a Rendrag® compatible connection system. The majority of our rental fleet is the Poseidon I style barge. It is the easiest of the three connection systems to assemble and knock down. The Poseidon 2 Barge has a Flexifloat® compatible connection system. If you already own Flexifloat barges and wish to rent or purchase additional units, this would be an option for you. The Poseidon 3 Barges has a Shugart® compatible connection system. If you already own Shugart® Barges, our units will pin up to theres, are less expensive to transport by truck and are easier to rig with the single pick lifting clevis in the top center of the barge.

Our corporate office and main inventory location is in Berne, 在. 我們也有位於平原的衛星配送場, WI; 可可, FL; 威爾頓, 紐約; 聖. 路易, MO; 新奧爾良, THE; 和利蘭, NC.

承包商負責從項目返回後對駁船的所有維修. 我們要求您在將設備搬上駁船時使用起重機墊來保護駁船表面. 這將防止頂部滾動. 這也將有助於將負載分散到駁船配置的較大部分. 任何焊接在駁船上的支架都必須拆除，並在返還駁船之前磨掉剩餘的銲件. 維修圖片和估價將盡快轉發給您. 維修費用將開具發票退還給您.

外底, sides and ends are fabricated with grade A36 – 1/4″ steel. The tops are fabricated with Patented Heavy Duty Roll Form, HSLA 鋼橋面板施工 20,000 psf concentrated load capacity.

We currently offer a ramp for the P2 – 5′ barges and are designing a similar ramp section for P1 – 5′ barges as well as P2 – 7′ barges. Another cost effective way to load your equipment on the barges is to use your 12″ wood crane mats. The barges should remain free floating while the equipment weight transitions from the land to the barge.

The Poseidon Barges are designed to be used only when floating in the water. “Beaching” the barges will create pivot points between the barge that is beached and the barge that is floating. Depending on the weight of the equipment, the connections will either crush in at the top or be pulled out at the bottom.

波塞冬 1, 波塞冬 2 & 波塞冬 3 barges which were built beginning in 2010 are built with a 18″ standard hatches in the tops of the barges. Older units are accessible using the 4 ballast tubes in the top corners of the barges.

There may be some options for Lease to Own or Financing, but they must be discussed prior to entering an agreement. There could be special terms or fees involved. 要么, you may finance through an outside banking institution. Leasecorp, Inc in Noblesville, IN has handled financing for some of our customers in the past.

Our sales representatives will assist you in setting up the barges. Typical setup depending on the size of the platform, can be completed in less then a day. This can be scheduled while arranging for delivery of the barges.

Each Poseidon 1, 波塞冬 2 or Poseidon 3 – 40’ x 10’ x 5’ barges will float 35,000 lbs dead weight at 2’6” draft. A 20’ x 10’ x 5’ barge will float 17,500 lbs dead weight at 2’6” draft. (For example, 6 – 40’ x 10’ x 5’ barges will float 210,000 lbs or 105 tons at 2’6” draft.) P2 – 7 駁船: 40′ = 27.1 tons at 3.5′ draft.

Poseidon I Barges
P1 – 40’ x 10’ x 5’ sections 23,500 lbs each
P1 – 20’ x 10’ x 5’ sections 12,600 lbs each
P1 – 10’ x 10’ x 5’ rake sections 6,500 lbs each
P1 – 5′ Spud Pocket 1,250 lbs each
40’ x 18″ Round Spuds 4,400 lbs each
30’ x 18″ Round Spuds 3,300 lbs each
20’ x 18″ Round Spuds 2,200 lbs each
P1 – 5′ Hairpin Connector Pins 55 lbs each

Poseidon II Barges
P2 – 40’ x 10’ x 5’ sections 23,500 lbs each
P2 – 40′ x 10′ x 7′ sections 33,000 lbs each
P2 – 20′ x 10′ x 5′ sections 12,500 lbs each
P2 – 20′ x 10′ x 7′ sections 17,070 lbs each
P2 – 5′ Spud Pockets 2,550 lbs each
P2 – 7′ Spud Pockets 4,350 lbse each
P2 – 7′ 24″ x 1/2″ x 40′ Round Spuds, 12,300 磅

Poseidon III Barges
P3 40’4″ x 10’4″ x 5′ Sections weight 23,700 lbs ea

The spuds are lowered into the ground below the surface of the water to anchor the barge in place. Depending on the surface of the ground and the water current, you may need to used 4 Spuds rather then 2 錨定到位駁船. 土豆可以使用絞盤系統或起重機線被升高的降低. 另外, 我們提供這些附著在駁船的頂部，可用於駁船扎開了個親密樹或橋橋面同行夾板。如果在任何時候電纜暴露在開闊水域的駁船和錨點之間, 它是為紀念與明亮的橙色領帶乙烯電纜關鍵，以警告任何人只要有一船或摩托艇電纜到位接近工作現場，並可能是一個危險.

定位樁可以升高，並與在駁船上的吊車或挖掘機降低. 有一個在定位樁頂部的吊耳. Make sure you have a choker that is 15′ – 20′ long so that when the spud is lowered into position on the river bottom, you do not need a ladder to climb up to release the crane line. 也, we lease and sell winches systems to raise and lower the spuds. Steel cable is not provided. Either 5/8″ or 3/4″ cable may be used depending on the type of winch leased or purchased.

Poseidon Sectional Barges are transported via tractor trailer trucks. We have local trucking companies who can haul two-Poseidon 1 波塞冬 2 or Poseidon 3 – 40’ x 10’ x 5’ trucks on a step deck trailer. There is a limited number of light weight trailer available so the more notice you give us the more likely we will be able to accommodate your needs. You may arrange for your own freight as well.

We will assist you in arranging freight. It is the contractor’s responsibility to pay for both incoming and outgoing freight.

The contractor is responsible for insuring the barges while they are in your possession. We will need a Certificate of Insurance naming Poseidon Barge, LTD as an “Additional Insured” under your general liability policy, plus listing us as a “Loss Payee” under your equipment floater policy for dual protection against physical damage. The insurance value would be the original purchase price.

我們提供 110 附加到我們的駁船部分的背面HP液壓駁船推單元. 本機具有一個可調螺距螺旋槳系統，提供 180 度正向和反向轉動. 使用我們的單位省去了全職隊長坐在拖船. 您也可以左右移動使用漁船與駁船 75 至 100 HP舷外引擎. 必須小心使用你的船或推膝蓋拖船時使用保險槓系統，以防止損壞駁船兩側.

沒有! 這將導致駁船損壞! 該駁船必須保持自由浮動，而設備是在駁船.

我們的駁船被設計成攜帶重量只有免費的，當在水中漂浮.

我們的駁船都配備了鎮流管駁船上的四個角. 有沒有在內部密封擋板牆. 壓載水可以加入，但必須在運輸之前駁船後方清除. 這可以通過使用一個小型便攜式水泵線向下穿過壓載管來完成，或者您可以打開上相對的兩端壓載管, 附加的空氣壓縮機線和吹出來的水的另一端.

你可以在租賃結束購買駁船但是我們不能對駁船的購買價格應用支付租賃款. 如果您想購買駁船, 購買術語協商議定鋒線.